Mikrotik wan failover reddit. 1 day ago ยท Hello I am using 2 WAN on a mikrotik (ether1 and ether2) and i have 2 subnets (native 192. Basically, default config covers most cases: when current gateway dies - mikrotik marks currently used route as down and therefore next available route (based on distance) is used, which is route from LTE interface. 0/24 and vlan10 192. I have added a fiber handoff into the 5009 with a public IP off of this connection. 10. 1. 0/24 use ether1 wan. Also at each subnet, if a wan fails i want to have failover the other wan and vice versa. Current solution isn't optimal as it takes a lot of time to failover and is rather fast to get back before primary link is stable enough. Config help - dual wan failover and traffic prioritisation Hello, I have two ISPs and I would like to have more advanced failover system than route distance on gateways. I use recursive routing and tried to achive that with mangle rules . As soon as I manually add a default route to my main connection gateway, this packetloss goes away. This site has a fiber connection as its primary. 0/24 ) I want clients on native 192. I am running ROS CHR on Proxmox. I have an RB5009 that is used at a remote site for OOB management of on-site equipment. Its WAN is plugged into an LTE device. 0/24 to use ether2 wan (starlink) while 192. Ping requests to the different responders were forced by routing marks to go out one src-natted gateway or the other. 168. Failover works fine, but I have a little bit of packetloss sometimes. Is it possible to set up a dual WAN failover that ties into their existing infrastructure? They don't use Mikrotik products and I don't want to touch their existing infrastructure. I currently have it configured like explained in the wiki. RB5009 WAN Failover Hi everyone. It was a fairly complicated MikroTik script, a couple of hundred lines, that used several ping responders. We use Zerotier as our OOB VPN. However, I've reached edge case - ISP's gateway is working fine, but still 'no internet' (ISP's upstream or is dead or upstream's upstream, who knows). In this case, basic failover Questions regarding WAN failover Hi, I have a backup internet connection that I want to use as failover. pszqza mrmanc sift mae pfzab vvre qzzfyl yzmgm pauus vxe